Towertalk
[Top] [All Lists]

Re: [TowerTalk] Tower bolts: drive out or unscrew?

To: "al.n6ta@gmail.com" <al.n6ta@gmail.com>, Mpridesti <mpridesti@yahoo.com>
Subject: Re: [TowerTalk] Tower bolts: drive out or unscrew?
From: Keith Dutson <kdutson@sbcglobal.net>
Date: Thu, 9 Sep 2021 11:30:40 +0000 (UTC)
List-post: <mailto:towertalk@contesting.com>
 I would likely use a battery powered impact wrench on the bolt, and box end or 
Vise-grip wrench on the nut.  Be sure to have an extra battery available to 
haul up when the impact wrench slows down.  Of course, you will also need a 
good burlap bag to hold the old bolts.
If you are going to use the tower sections again, I highly recommend 
re-galvanizing.  Price here is less than 50 cents per pound of finished steel.  
At 70 pounds per section, that is 420X.50 = $210, which is well worth the 
treatment.  May have to clean the old sections before re-dipping.  I would add 
another $200 for that task.
73, Keith NM5G
    On Thursday, September 9, 2021, 05:28:08 AM CDT, Mpridesti via TowerTalk 
<towertalk@contesting.com> wrote:  
 
 Al

Since you plan to reuse the tower and assuming the bolts are old, don’t bother 
saving the old ones. Nicer to have new hardware and it’s a minimal expense to 
you or a new owner.  

So drive them out by whatever means. 

Regards,

Mark, K1RX


> On Sep 9, 2021, at 1:16 AM, al.n6ta@gmail.com wrote:
> 
> I must take apart my guyed 60' Rohn 45 and some of the bolts are not going
> to come out without some encouragement.  I could drive them out with a
> hammer and punch or unscrew them through the thru holes in the tower's legs.
> The tower will be used again so I do not want to mess it up unnecessarily.
> Of course, I do not care about the bolts which go to the scrap metal
> recyclers.
> 
> 
> 
> Thanks in advance!
> 
> Al-N6TA
> 
> 
> 
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
  
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>