I install SS cap screws from the bottom with a SS lock washer and nut installed
for retention. Then the radials with crimped lugs are installed on these
"studs" with a second washer and nut. All suitably dosed with anti-seize.
Wes N7WS
On 8/28/2018 10:59 AM, Roger D Johnson wrote:
I just wish the DXE radial plate had the holes tapped for 1/4-20. It's a pain
getting to the underside with a wrench to remove the nut when you have a bunch
of radials attached.
73, Roger
On 8/24/2018 1:46 PM, W0MU Mike Fatchett wrote:
DXE makes great radial plate. That is really not what the question is about.
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|