Roger try putting some thick walled heat shrink over the jaws like 3/4" and
shrink it down. Yes it needs to be replaced every so often but it sure
protects the connector shell.
Doug
I wasn't born in Saskatchewan, but I got here as soon as I could.
-----Original Message-----
Use a thin sheet of Silicone rubber in a "U" shape inside the pliers to
protect the connectors. It works for me, but I'm often too impatient to
worry about a cheap PL-259 (Even Silver plated Amphenols are cheap)
BNCs are basically miniature N connectors, bur they lose a lot to scale
and are very weak. I've never seen them used outdoors. It tales little
strength to pull the coax out of one, making them an interconnect only
for me.
---
This email has been checked for viruses by Avast antivirus software.
http://www.avast.com
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|