Get the Harger ground bar.
73, Keith NM5G
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of
Charlie Gallo
Sent: Thursday, March 20, 2014 12:53 PM
To: rfi@contesting.com; towertalk@contesting.com
Subject: [TowerTalk] Back of desk grounding buss
Hey Gang,
Sort of antenna, sort of RFI, more safety..
I've decided my back of desk grounding situation needs to be improved
Now, we all know the standard is a nice, thick copper buss. Question is,
how thick? - this will then be run down to the panel/ground rod
Is Brass/Aluminum/Copper PIPE a valid alternative? If aluminium, again, how
large (I normally have round up to about 3" diameter sitting in the shop, as
well an AL plate (various sizes, 3/16 thick up to 6" wide is everyday, and I
have angle up to 5" wide legs, 1/4" thick around, and blocks up to 2" thick
and 4" wide hanging around
I intend to silver braze most of my connections, but obviously that won't
work to an Al plate, That I'd drill, tap, and either use studs with nuts,
or screws
Again, we aren't talking the wall pass through here, but the buss at the
back of the desk
--
73 de KG2V - Charles Gallo
Quality Custom Machine-shop work for the radio amateur (sm)
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|