These work pretty good, look nice too:
http://www.kf7p.com/KF7P/CoaxBus.html
Chris
KF7P
On Mar 20, 2014, at 11:53 AM, Charlie Gallo wrote:
> Hey Gang,
> Sort of antenna, sort of RFI, more safety..
>
> I've decided my back of desk grounding situation needs to be improved
>
> Now, we all know the standard is a nice, thick copper buss. Question is, how
> thick? - this will then be run down to the panel/ground rod
>
> Is Brass/Aluminum/Copper PIPE a valid alternative? If aluminium, again, how
> large (I normally have round up to about 3" diameter sitting in the shop, as
> well an AL plate (various sizes, 3/16 thick up to 6" wide is everyday, and I
> have angle up to 5" wide legs, 1/4" thick around, and blocks up to 2" thick
> and 4" wide hanging around
>
> I intend to silver braze most of my connections, but obviously that won't
> work to an Al plate, That I'd drill, tap, and either use studs with nuts,
> or screws
>
> Again, we aren't talking the wall pass through here, but the buss at the back
> of the desk
>
> --
> 73 de KG2V - Charles Gallo
> Quality Custom Machine-shop work for the radio amateur (sm)
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|