Hi
I got a tip from DL2OBO Tom to check the soldering on the relaybox, it can
be bad soldering after transport, I didn?t thought about that :) :)
73s Rag LA6FJA
-----Opprinnelig melding-----
Fra: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] På vegne av LA6FJA/K3RAG Stein
Roar Brobakken
Sendt: 28. oktober 2008 22:40
Til: 'Tower Talk'
Kopi: topband@contesting.com
Emne: [TowerTalk] Comtek PVS-2 80m Box with malfunction
Hi
I have bougth a new Comtek PVS-2 80m box with malfunction in one direction.
This is connected to two similar GP's for 80m + a MFJ 50 ohm dummy load.
When I switch to direction 1 I get high SWR(ant 1 connection), and direction
3 is ok (antenna 2 conntection).
Maybe the relay don't switch properly?
I have the export unit for 240VAC to 12VDC.
I have checked the wiring and it is ok.
I have email comtek System, but no reply.
Anyone have a same experience?
73s Rag LA6FJA
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
No virus found in this incoming message.
Checked by AVG - http://www.avg.com
Version: 8.0.175 / Virus Database: 270.8.4/1750 - Release Date: 27.10.2008
18:14
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|