Generally I agree except for a small but critical point.....
If you are using Davis Bury-Flex you will need the larger center pin ID of
the 83-1SP.
Yeah, yeah....I know you can probably find the el' cheapo connectors that
will fit the BF but I have never seen any....and I ain't gonna look.
One thing I will never do though is cut any strands of the center conductor
to make it fit some crummy connector that I have to scrape to get solder to
flow.
50 cents is not even chump change.
Get the good stuff....parts is not parts.
Regards
Dave Harmon
K6XYZ[at]sbcglobal[dot]net
Sperry, Ok.
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of WA6RKN
Sent: Tuesday, October 28, 2008 1:34 PM
To: Tower Talk
Subject: Re: [TowerTalk] Amphenol PL259
Teflon is Teflon, no matter who makes the connector. Unless you are using a
3000 watt soldering gun, at full power, one is not going to melt the Teflon
dielectric. (When using the silver plated connectors!) I just can't see
paying the 50 cents extra apiece for the Amphenols' when the no name
silver/Teflon connectors work (and last) just as well.
Joe Wolfe
WA6RKN
----- Original Message -----
From: "Jim Brown" <jim@audiosystemsgroup.com>
Subject: Re: [TowerTalk] Amphenol PL259
> On Tue, 28 Oct 2008 13:23:32 -0400, Pete Michaelis - N8TR wrote:
> As to the cheapies, I've melted dielectrics of the connectors themselves.
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|