One of the locals had a great scheme, once you connect the larger
motor wires the rest follow the Resistor Color Code (B-B-R-O, etc).
No need to write anything down.
73, Dick, W1KSZ
> From: k5fnq@cox.net> To: towertalk@contesting.com> Date: Mon, 4 Aug 2008
> 20:46:39 -0500> Subject: [TowerTalk] Tailtwister Rotor wires> > OK, I admit
> to screwing up. but it was for a good cause.> Local was doing tower work and
> had rotor problems. I volunteered to come > home and get my TX2 control box
> in case his was bad.> I wrote down the color code when I took off the wires
> and have now lost the > little piece of paper I used.> > I think I have it
> right as the manual has the color codes, it has just been > up too long to be
> sure.> > I see in the manual a way to check resistance on the wires.> Is this
> the only way to try and figure out the wiring or do I have to get > someone
> up the tower to check?> Yeah it was a dumb move, but all for a good cause at
> the time.> Art K5FNQ> > _______________________________________________> > >
> > _______________________________________________> TowerTalk mailing list>
> TowerTalk@contesting.com> http://lists.contesting.com/mailman/listinfo/tow
ertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|