OK, I admit to screwing up. but it was for a good cause.
Local was doing tower work and had rotor problems. I volunteered to come
home and get my TX2 control box in case his was bad.
I wrote down the color code when I took off the wires and have now lost the
little piece of paper I used.
I think I have it right as the manual has the color codes, it has just been
up too long to be sure.
I see in the manual a way to check resistance on the wires.
Is this the only way to try and figure out the wiring or do I have to get
someone up the tower to check?
Yeah it was a dumb move, but all for a good cause at the time.
Art K5FNQ
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|