Towertalk
[Top] [All Lists]

Re: [TowerTalk] Pipe Cutters

To: Bill Turner <dezrat@copper.net>
Subject: Re: [TowerTalk] Pipe Cutters
From: "Richard (Rick) Karlquist" <richard@karlquist.com>
Date: Sat, 08 Dec 2007 12:33:57 -0800
List-post: <mailto:towertalk@contesting.com>
See:

http://yarchive.net/metal/aluminum_sawing.html

Rick N6RK

Bill Turner wrote:
> ORIGINAL MESSAGE:
> 
> On Fri, 07 Dec 2007 23:32:32 -0800, "Richard (Rick) Karlquist"
> <richard@karlquist.com> wrote:
> 
>> Are you talking about an abrasive type blade?
>> Those are only for steel, not aluminum.
>>
>> Rick N6RK
> 
> ------------ REPLY FOLLOWS ------------
> 
> Really? I have used an abrasive blade on my table saw to cut aluminum
> for years with no problem, but that does not mean it is the best
> choice. Please tell me why it is not recommended and what would be the
> best blade.
> 
> Thanks,
> 
> 73, Bill W6WRT
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
> 
> 
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>