Towertalk
[Top] [All Lists]

Re: [TowerTalk] Pipe Cutters

To: TowerTalk <TowerTalk@contesting.com>
Subject: Re: [TowerTalk] Pipe Cutters
From: Jeff Goldman <k3dua@erols.com>
Date: Sat, 8 Dec 2007 09:59:29 -0500
List-post: <mailto:towertalk@contesting.com>
Aluminum is soft and what happens, over time, is that the small bits of 
aluminum build up in the open pores of the abrasive wheel and the 
forces involved will sometimes cause the wheel to crack and come apart 
- - and pieces of the wheel can go flying in many directions and you 
could be injured.  Definitely a no-no.  If you want to use a power saw, 
use a carbide tipped regular wood type blade, not the abrasive wheels 
that are for steel ONLY.

Jeff, K3DUA


On Dec 8, 2007, at 9:44 AM, Bill Turner wrote:

> ORIGINAL MESSAGE:
>
> On Fri, 07 Dec 2007 23:32:32 -0800, "Richard (Rick) Karlquist"
> <richard@karlquist.com> wrote:
>
>> Are you talking about an abrasive type blade?
>> Those are only for steel, not aluminum.
>>
>> Rick N6RK
>
> ------------ REPLY FOLLOWS ------------
>
> Really? I have used an abrasive blade on my table saw to cut aluminum
> for years with no problem, but that does not mean it is the best
> choice. Please tell me why it is not recommended and what would be the
> best blade.
>
> Thanks,
>
> 73, Bill W6WRT
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>