I can see taping only to the boom if you have only one antenna on the mast.
If there is more than one antenna on the mast, you almost have to tape the
cables to the mast below the bottom antenna, before starting the loop.
Right?
John wa5zup
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Bill Turner
Sent: Thursday, July 19, 2007 6:21 PM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] Coax loop
ORIGINAL MESSAGE:
On Tue, 17 Jul 2007 17:45:26 -0600, "James C. Garland"
<4cx250b@muohio.edu> wrote:
>If it's the rotator loop, then it should be taped to the mast along
>several inches (minimum), and then taped again to the tower
------------ REPLY FOLLOWS ------------
I'm not clear on why you want to tape the coax to the mast. Mine is
taped to the boom, circles around the mast and is taped to the tower.
Never touches the mast at all. By taping to the mast you are reducing
the radius of the circle and I don't see why you would want to do
that.
What does taping to the mast gain you?
Bill W6WRT
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|