Topband
[Top] [All Lists]

Re: Topband: choke/bleeder resistor on RXvertical?

To: Mike Waters <mikewate@gmail.com>, Gary - K7EK <gary.k7ek@yahoo.com>
Subject: Re: Topband: choke/bleeder resistor on RXvertical?
From: Dale Putnam <daleputnam@hotmail.com>
Date: Fri, 21 Dec 2018 15:20:19 +0000
List-post: <mailto:topband@contesting.com>
I put resistors (always 100k or more) across EVERY feedline - at the antenna. I 
keep a chart of what antenna has which value resistor.
Two reasons for the chart.. if the resistor changes value, I can find it 
quickly. IF I drop a coax into a couple others, I can quickly determine which 
antenna is connected with which feeder. The resistors are all under 2 watt. 
Since I generally run qrp, the summertime "missing" resistor, leads me to 
believe "there went another strike".. and the discolored ones, make me believe 
that even at 2 watts, the wind static has power.

Have a great day,

Dale - WC7S in Wy

"Actions speak louder than words"


________________________________
From: Topband <topband-bounces@contesting.com> on behalf of Gary - K7EK via 
Topband <topband@contesting.com>
Sent: Friday, December 21, 2018 8:11 AM
To: Mike Waters
Cc: topband
Subject: Re: Topband: choke/bleeder resistor on RXvertical?

Question about the use of Ohmite bleeder resistors: What are the considerations 
relative to power rating in this application? Would  a 2w OX or OY ceramic 
resistor survive extended use of full legal amateur power limit on such modes 
as RTTY, FT8, JT65A, SSTV, and various other high duty cycle digital modes, and 
AM voice, etc?

Best regards,

Gary, K7EK

⁣Sent from BlueMail

On Dec 19, 2018, 13:08, at 13:08, Mike Waters <mikewate@gmail.com> wrote:
>ALL my antennas have Ohmite OX or OY resistors from the antenna to
>ground.
>From 56k to a megohm or three. Doesn't everybody? :-)
>
>Ditto at dipole feedpoints.
>
>73, Mike
>www.w0btu.com<http://www.w0btu.com>
>
>On Wed, Dec 19, 2018, 12:19 PM Jamie WW3S <ww3s@zoominternet.net>
>wrote:
>
>> Since verticals are know to be "noisy" on receive, and a fix is a rf
>choke
>> or bleeder resistor to ground, anyone try that on short verticals
>used for
>> receive only to quiet some noise?
>> _________________
>> Searchable Archives: http://www.contesting.com/_topband - Topband
>> Reflector
>>
>_________________
>Searchable Archives: http://www.contesting.com/_topband - Topband
>Reflector
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
<Prev in Thread] Current Thread [Next in Thread>