Paul,
I use old plastic soda bottles, 16 or 20 oz size. Cut off the threaded
top so there's a hole about 2 in. diameter and it just pops over the end
of the coax, hardline, etc. where the transformer is or over the
termination resistor at the other end. Credit for this idea goes to VE1ZZ.
73/Jon AA1K
On 4/23/2011 08:45 AM, Paul Staupe wrote:
> I've put up several Beverages this Spring and am looking for suitable
> weatherproof UV resistant plastic enclosures to mount the feed and
> termination hardware.
>
> Does anyone have any suggestions?
>
> Best regards,
>
> Paul W0AD
> _______________________________________________
> UR RST IS ... ... ..9 QSB QSB - hw? BK
>
_______________________________________________
UR RST IS ... ... ..9 QSB QSB - hw? BK
|