I made a fairly comprehensive list of Ten-Tec filter model numbers, stock
numbers, bandwidths, etc. It has been posted on a website. Using only my
phone it's too hard for me to find. If you don't find it sooner, I will
tell you where to find in a few days when I get back to my PC. DE N6KB.
On Fri, Jan 4, 2019, 18:38 Phil Erickson <phil.erickson@gmail.com wrote:
> Hi all,
>
> If this list will indulge a further curiosity:
>
> With my VI+ back together, I measured the filter response of the two SSB
> filters @ 2nd IF : the default one (2.4 kHz nominal) and the one that I
> thought was 1.8 kHz (supposed to be Ten-Tec #288).
>
> Procedure for each filter:
>
> - Injected a test tone from signal generator at a known frequency
> - set the radio for LSB
> - AGC off
> - slowly move the tuning dial upwards 100 Hz at a time away from the
> frequency
> - record freq offset and approximate tone amplitude in V using a Tek scope
> (1 Mohm input) clipped to the External Speaker leads
> - plotted 20*log10(V) as a function of frequency
>
> To my surprise, the 1.8 kHz has almost exactly the same response width as
> the 2.4 kHz. It makes me think that someone accidentally installed a 2.4
> kHz in that position, as I definitely expected the 1.8 to be narrower.
>
> Is there any marking on the standard TT filters that allows you to tell
> them apart? I couldn't find any, but I didn't lift the filters off the PBT
> board to see the underside. (I note with some interest as well that Inrad
> didn't bother to make anything narrower than 2.1 kHz for the 2nd IF. Was
> SSB somewhat of an afterthought on this radio?)
>
> 73
> Phil W1PJE
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|