Thanks Steve. I'm finding that I can use 9.000MHz for i.f., cw offset is
equal to (minus) sidetone frequency, USB offset is -3000Hz and LSB offset
is zero.
Yes, I'm using OmniRig to interface to the Omni 6+.
HDSDR software has a neat "Mirror RF Spectrum in general" checkbox that
makes the spectrum move correctly with the Omni 6/SDRPlay combo. Back when
I used an Orion/LP-Pan, I never saw the flipped spectrum issue.
73, Barry N1EU
On Sat, Dec 24, 2016 at 7:21 PM, Steve Ellington <steven4lq@gmail.com>
wrote:
> Barry
> I fiddled with this on a Corsair II. The offset for it was 750 Hz for cw
> but on the O6 it would depend on your sidetone frequency setting. I would
> guess 1500 Hz for SSB +/-. I lost interest because it tuned backwards.
> IOW.... tuning up the band caused the signals to move down. It's an (IF)
> thing:*)
> I would think OmniRig would be needed to interface the rig to SDR-C but I
> used HDSDR. It can operate OmniRig which in turn operates most any rig via
> serial port.
> Let us know how it goes.
> Steve N4LQ
>
> On Sat, Dec 24, 2016 at 1:48 PM, Barry N1EU <barry.n1eu@gmail.com> wrote:
>
> > Can anybody please provide the correct freq settings to use with
> panadapter
> > software being driven off the 9MHz i.f. output:
> >
> > IF OUTPUT 9.???.??? MHz
> > Offsets CW ??? Hz
> > LSB ??? Hz
> > USB ??? Hz
> >
> > FWIW, I'm driving an SDRPlay RSP1 off my Omni 6+ 9MHz i.f. through a
> > Clifton Labs Z10000B buffer amp. I'm using SDR Console v3 software.
> This
> > looks like it's going to be a very cool setup. I am fully documenting
> the
> > install.
> >
> > Thanks & 73,
> > Barry N1EU
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|