Barry,
If you have a drill press, I would use a reverse, left hand drill bit.
On 12/24/2016 11:00 AM, tentec-request@contesting.com wrote:
Send TenTec mailing list submissions to
tentec@contesting.com
To subscribe or unsubscribe via the World Wide Web, visit
http://lists.contesting.com/mailman/listinfo/tentec
or, via email, send a message with subject or body 'help' to
tentec-request@contesting.com
You can reach the person managing the list at
tentec-owner@contesting.com
When replying, please edit your Subject line so it is more specific
than "Re: Contents of TenTec digest..."
Today's Topics:
1. HELP with broken off screw threads (Barry N1EU)
2. Re: HELP with broken off screw threads (Peter Frenning [OZ1PIF])
3. HELP with broken off screw threads (Tom Hellem)
4. Re: HELP with broken off screw threads (Barry N1EU)
5. Re: HELP with broken off screw threads (Peter Frenning [OZ1PIF])
6. Re: HELP with broken off screw threads (Bryan Lee Cornwell)
7. Re: HELP with broken off screw threads (Mike Bryce)
8. Re: HELP with broken off screw threads (Barry N1EU)
9. SOLVED Re: HELP with broken off screw threads (Barry N1EU)
----------------------------------------------------------------------
Message: 1
Date: Sat, 24 Dec 2016 15:02:05 +0000
From: Barry N1EU <barry.n1eu@gmail.com>
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: [TenTec] HELP with broken off screw threads
Message-ID:
<CAFmfzDs=+mikAufBSFOPgj33cg=tLnbDK0A0i7X7GC8WjKo0Zg@mail.gmail.com>
Content-Type: text/plain; charset=UTF-8
The threaded end of an aluminum screw broke off in one of the PCB mounting
posts in my Omni 6+. Please have a look here: http://n1eu.com/screw1.jpg
I'd very much appreciate advice on how to remove that screw end.
Thanks & 73,
Barry N1EU
------------------------------
Message: 2
Date: Sat, 24 Dec 2016 16:06:59 +0100
From: "Peter Frenning [OZ1PIF]" <peter@frenning.dk>
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] HELP with broken off screw threads
Message-ID: <66140d57-69b6-c3f1-0bdf-6c5c64c6a16c@frenning.dk>
Content-Type: text/plain; charset=utf-8; format=flowed
Den 24-12-2016 kl. 16:02 skrev Barry N1EU:
The threaded end of an aluminum screw broke off in one of the PCB mounting
posts in my Omni 6+. Please have a look here: http://n1eu.com/screw1.jpg
I'd very much appreciate advice on how to remove that screw end.
Thanks & 73,
Barry N1EU
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
Sorry Barry, I only get a partial picture...
--
Paul Ramey
WG0G
612-747-1244
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|
