On Sat,12/24/2016 10:48 AM, Barry N1EU wrote:
Can anybody please provide the correct freq settings to use with panadapter
software being driven off the 9MHz i.f. output:
IF OUTPUT 9.???.??? MHz
Offsets CW ??? Hz
LSB ??? Hz
USB ??? Hz
Hi Barry,
Couldn't you figure this out by tuning in a signal on the radio, then
listening on the SDRPlay to see where it appears? I would start with CW.
If you have more than one radio, TX on the other radio and find it on
the radio with the SDRPlay at the IF.
FWIW, I'm driving an SDRPlay RSP1 off my Omni 6+ 9MHz i.f. through a
Clifton Labs Z10000B buffer amp. I'm using SDR Console v3 software. This
looks like it's going to be a very cool setup. I am fully documenting the
install.
Great. It would be quite helpful to know whether the buffer amp improves
performance. Perhaps you might test in small signal and large signal
conditions with and without it.
73, Jim K9YC
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|