well…shoot..
that lasted all of 1/2 hour!
The past week or so, I has been inoperative on boot up…
and it boots up with swishing noise that repeats itself or it seems to work but
can’t her anything but background (processor) noise, or receive sigs are way
down in the background.
So for the time being it will be designated back up rig in the closet…and will
run my omni 7 for the duration.
I also have a chance ti purchase an unknown condition orion sub receiver board
but not too sure want to mess with that.
I seems to be something that is not letting the sub receiver board connect to
the rest of the system correctly..
I have not yet done much in the way of diagnostics…but will take some time this
fall to pull the sub receive board and see if anything amiss…cold solder
joints, etc, clean contacts and trace down cabling.
On Oct 12, 2015, at 9:07 AM, denton sprague <denton@oregontrail.net> wrote:
> a little followup..
> sub rx was inoperable this am…booted up with sub rx on ant 1 and vfo b
> enabled yesterday.
>
> after letting the rig on for about 3 hours, I rebooted the rig with sub rx
> off on the ant and vfo buttons.
>
> after reboot, enabled sub rx on vfo b and ant 1 buttons. Sub rx now works
> normally….
>
> On Oct 11, 2015, at 11:27 AM, denton sprague <denton@oregontrail.net> wrote:
>
>> thanks…apparently that was it om!!
>> On Oct 11, 2015, at 11:13 AM, Tim Wininger <ky5rtim@gmail.com> wrote:
>>
>>> Need both SUB RX VFO and Ant1 SUB RX depressed.
>>>
>>> That's how I use this sub rcvr hr. Hope it's just that.
>>>
>>> GD Tim, AB4B
>>>
>>> On Sun, Oct 11, 2015 at 12:01 PM, denton sprague <denton@oregontrail.net>
>>> wrote:
>>>
>>>>
>>>> Hi all…my trusty Orion that came back from TT for processor board
>>>> replacement a few months ago seems to have no receive signals…this
>>>> happened this am when booting up the rig.
>>>> I use ant 1 as main rx/tx as well as sub rx.
>>>> I can hear the sub noise come up when pressing the sub rx button, but
>>>> evidently getting no signals from the antenna.
>>>> I have only one hf antenna.
>>>> Did a master reset to no avail.
>>>> loose cable maybe??
>>>> _______________________________________________
>>>> TenTec mailing list
>>>> TenTec@contesting.com
>>>> http://lists.contesting.com/mailman/listinfo/tentec
>>>>
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|