a little followup..
sub rx was inoperable this am…booted up with sub rx on ant 1 and vfo b enabled
yesterday.
after letting the rig on for about 3 hours, I rebooted the rig with sub rx off
on the ant and vfo buttons.
after reboot, enabled sub rx on vfo b and ant 1 buttons. Sub rx now works
normally….
On Oct 11, 2015, at 11:27 AM, denton sprague <denton@oregontrail.net> wrote:
> thanks…apparently that was it om!!
> On Oct 11, 2015, at 11:13 AM, Tim Wininger <ky5rtim@gmail.com> wrote:
>
>> Need both SUB RX VFO and Ant1 SUB RX depressed.
>>
>> That's how I use this sub rcvr hr. Hope it's just that.
>>
>> GD Tim, AB4B
>>
>> On Sun, Oct 11, 2015 at 12:01 PM, denton sprague <denton@oregontrail.net>
>> wrote:
>>
>>>
>>> Hi all…my trusty Orion that came back from TT for processor board
>>> replacement a few months ago seems to have no receive signals…this
>>> happened this am when booting up the rig.
>>> I use ant 1 as main rx/tx as well as sub rx.
>>> I can hear the sub noise come up when pressing the sub rx button, but
>>> evidently getting no signals from the antenna.
>>> I have only one hf antenna.
>>> Did a master reset to no avail.
>>> loose cable maybe??
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|