Hello Barry.
Sorry i made mistake, this is measure in today:
All is measure in cable side
8-pin DIN male IN CABLE to 25DB male:
8 --> 16
2 --> 14
7 --> 8
3 --> 6
Here is link picture, where i found 8-pin DIN connectors number:
left side picture CABLE SIDE:
http://freespace.virgin.net/tom.baldwin/pinout-8din.html
I hope it works now, if not ask,
sorry my mistake.
73 Harri OH3PC
12:42, Barry N1EU kirjoitti:
> Hi Harri,
>
> I wired up my 302 remote to the DB25 on the Omni 6+ and it is not tuning.
> Can you confirm that the pin 1, 6, 2, and 8 connections that you gave me
> for the DIN plug from the 302 are numbered the same as this diagram?
>
> [image: Image result for 8-pin din connector]
>
> When I connect an oscilloscope to the 4 connections, I see +5V and ground
> but I don't see any encoder pulses on the other two pins
>
> Is there a schematic anywhere for the 302?
>
> Thanks & 73,
> Barry N1EU
>
> On Sun, Mar 8, 2015 at 10:00 AM, Harri Sillanpää <harsil@phnet.fi> wrote:
>
> > Here is how i made it.
> >
> > NOTE ! ONLY KNOB WORKS, NOT KEYBOARD!
> >
> > CONNECT 8-PIN din Male to 25 pin DB-connector:
> >
> > 8-pin DIN connector 25-pin DB-connector
> >
> > pin 1 to pin 6
> > pin 6 to pin 8
> > pin 2 to pin 14
> > pin 8 to pin 16
> >
> > Only 4-wires need.
> >
> > i can send to pictures, if someone wants.
> >
> > 73 Harri OH3PC
> >
> >
> > --
> > Harri Sillanpaa
> > Varpusenkatu 12
> > FI-15610 LAHTI
> > FINLAND
> > 040/7599172
> >
> >
> >
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
--
Harri Sillanpaa
Varpusenkatu 12
FI-15610 LAHTI
FINLAND
040/7599172
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|