Hi Harri,
I wired up my 302 remote to the DB25 on the Omni 6+ and it is not tuning.
Can you confirm that the pin 1, 6, 2, and 8 connections that you gave me
for the DIN plug from the 302 are numbered the same as this diagram?
[image: Image result for 8-pin din connector]
When I connect an oscilloscope to the 4 connections, I see +5V and ground
but I don't see any encoder pulses on the other two pins
Is there a schematic anywhere for the 302?
Thanks & 73,
Barry N1EU
On Sun, Mar 8, 2015 at 10:00 AM, Harri Sillanpää <harsil@phnet.fi> wrote:
> Here is how i made it.
>
> NOTE ! ONLY KNOB WORKS, NOT KEYBOARD!
>
> CONNECT 8-PIN din Male to 25 pin DB-connector:
>
> 8-pin DIN connector 25-pin DB-connector
>
> pin 1 to pin 6
> pin 6 to pin 8
> pin 2 to pin 14
> pin 8 to pin 16
>
> Only 4-wires need.
>
> i can send to pictures, if someone wants.
>
> 73 Harri OH3PC
>
>
> --
> Harri Sillanpaa
> Varpusenkatu 12
> FI-15610 LAHTI
> FINLAND
> 040/7599172
>
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|