be sure to get the com port right and use this setup for the Orion:
DTR=CW RTS=PTTTx=1 baud 57600, N, 8, 1 Handshake, Hanshake
-----Original Message-----
From: Barry N1EU
Sent: Monday, June 24, 2013 12:34 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] N1MM Help
If you choose "Orion" in the Config-Ports menu for the COM port that you
are using, it will show you the suggested settings that will work with the
Orion. The trickiest part is figuring out which COM port your cable is
connected to.
73, Barry N1EU
On Mon, Jun 24, 2013 at 6:11 PM, Scott Weiss <s.weiss018@gmail.com> wrote:
To all,
Could someone please help me with hooking up N1MM to my Orion I. I'm
having a tremendous brain fart with this.
Scott
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|