He's got it right.
73
Bob, K4TAX
----- Original Message -----
From: "Denton" <denton@oregontrail.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, March 17, 2008 6:37 PM
Subject: Re: [TenTec] OmniV and PSK31
> Maybe this will help a bit....the Jupiter, Like the Pegasus which I had in
> the past, uses digital audio processing, and is much more forgiving of
> audio
> drive than either the Corsair II, Omni vi or other rigs that use analog
> audio sampling. I could typically set the Pegs mike gain and/or soundcard
> levels to just below when the alc light would come on and still get nice
> clean psk imd reports.
> But I finally would up leaving the xmit level at full output and set the
> soundcard input to about 30 watts drive.
> ----- Original Message -----
> From: "Larry Rockne" <wa7hdz@clearwire.net>
> To: <tentec@contesting.com>
> Sent: Monday, March 17, 2008 4:26 PM
> Subject: Re: [TenTec] OmniV and PSK31
>
>
>>I don't have an OMNI mine is a Jupiter, and hve been told by several hams
>>and TT to run my 'RF output'
>> at 100% out and use the soundcard and interface to adjust the meter
>> reading to ~30 watts.
>> However, I'd much rather adjust the R.F. out to say 30 watts and leave it
>> set.
>> A note to K4TAX: I am not familiar with the OMNI, but with the jupiter
>> they trll me to set the mic level the same as I would SSB. Your post says
>> to set the mic level to 30 watts. What about your R.F. out setting?
>> The more I read about PSK and the TT the confusder I gets. Hi
>> Larry WA7HDZ
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|