Hi Allan
Another tip: when setting up for PSK set output at 100 watts,
then adjust soundcard so that PSK sig is 25-30 watts max on
output meter. Make sure that you have computer sounds disabled,
or use a dedicated computer for PSK. Have fun
ron
K3MIY
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com]On Behalf Of Verne Smith
Sent: Sunday, March 16, 2008 3:33 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] OmniV and PSK31 -- any experience to be shared??
if u want to alienate ur selfin the psk world run full out---------u will
not need fan on psk 25 or 30 watts is max or u are the only signal seen on
waterfall----this really pisses off the rest of the troops--------the beauty
of psk is the low power and long distances covered-------
rember be considerate low power and good imd
verne
w7grn
----- Original Message -----
From: "Allan Taylor" <k7gt.cw@gmail.com>
To: <tentec@contesting.com>
Sent: Sunday, March 16, 2008 7:25 AM
Subject: [TenTec] OmniV and PSK31 -- any experience to be shared??
> My backup Tentec rig is an OmniV. After my OmniVI returns from factory
> service and frees up the V, it (the OmniV)
> will be used for PSK31. I am absolutely inexperienced with PSK and
> would greatly appreciate shared experience and
> issues that may arise when using the V for PSK. I will be adding the
> TT fan kit to allow running 'full out' in PSK.
>
> --
> 73 Allan K7GT
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
> --
> No virus found in this incoming message.
> Checked by AVG.
> Version: 7.5.519 / Virus Database: 269.21.7/1330 - Release Date: 3/15/2008
> 2:36 PM
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|