Maybe this will help a bit....the Jupiter, Like the Pegasus which I had in
the past, uses digital audio processing, and is much more forgiving of audio
drive than either the Corsair II, Omni vi or other rigs that use analog
audio sampling. I could typically set the Pegs mike gain and/or soundcard
levels to just below when the alc light would come on and still get nice
clean psk imd reports.
But I finally would up leaving the xmit level at full output and set the
soundcard input to about 30 watts drive.
----- Original Message -----
From: "Larry Rockne" <wa7hdz@clearwire.net>
To: <tentec@contesting.com>
Sent: Monday, March 17, 2008 4:26 PM
Subject: Re: [TenTec] OmniV and PSK31
>I don't have an OMNI mine is a Jupiter, and hve been told by several hams
>and TT to run my 'RF output'
> at 100% out and use the soundcard and interface to adjust the meter
> reading to ~30 watts.
> However, I'd much rather adjust the R.F. out to say 30 watts and leave it
> set.
> A note to K4TAX: I am not familiar with the OMNI, but with the jupiter
> they trll me to set the mic level the same as I would SSB. Your post says
> to set the mic level to 30 watts. What about your R.F. out setting?
> The more I read about PSK and the TT the confusder I gets. Hi
> Larry WA7HDZ
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|