Re: [TenTec] Orion I CRT Resolved!!!

["DAVID LEDUC" <n1ix@verizon.net>]

I forgot to mention that I had tried two different power supplies and I
still had the problem. I just replaced the end of the power cord and the
problem went away. 
Thanks for the help!
Dave N1IX

-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of DAVID LEDUC
Sent: Sunday, May 14, 2006 8:25 PM
To: 'Discussion of Ten-Tec Equipment'
Subject: [TenTec] Orion I CRT

I have an Orion I that I recently purchased used. I have noticed that the
CRT display flashes on and off with each dot and dash that I send. If I
reduce the power output to 50 watts or less the problem goes away. The SWR
is 1:1 and the Orion is properly grounded.

Is this normal? 

Dave N1IX

 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec