Boy, does that sound like a 'poor' power supply regulation problem OR the
momentary high-current requirement is causing the power supply to go into
fold-back.... take your pick... Jim Reed.
----- Original Message -----
From: DAVID LEDUC
To: 'Discussion of Ten-Tec Equipment'
Sent: Sunday, May 14, 2006 20:24
Subject: [TenTec] Orion I CRT
I have an Orion I that I recently purchased used. I have noticed that the
CRT display flashes on and off with each dot and dash that I send. If I
reduce the power output to 50 watts or less the problem goes away. The SWR
is 1:1 and the Orion is properly grounded.
Is this normal?
Dave N1IX
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|