To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
---|---|
Subject: | Re: [TenTec] Omni six-- heat related IF gain problem |
From: | Barry Gross <barry.n1eu@gmail.com> |
Reply-to: | Barry Gross <barry.n1eu@gmail.com>,Discussion of Ten-Tec Equipment <tentec@contesting.com> |
Date: | Wed, 13 Jul 2005 15:16:47 -0400 |
List-post: | <mailto:tentec@contesting.com> |
On 7/13/05, Chuck Guenther <ni0c@earthlink.net> wrote: > This is the first I've heard of anyone installing cooling fans in the Omni 6. Actually, this wasn't an uncommon topic a few years back. Personally, I found that my PBT settings were shifted dramatically during cw contesting due to internal heat buildup. I used an external fan blowing on the rear heatsink which seemed to help, but the internal cooling fan always seemed a good solution to me. 73, Barry N1EU _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TenTec] Vertical Dipole "Fringe Benefits", Robert & Linda McGraw K4TAX |
---|---|
Next by Date: | [TenTec] FS: Paragon/PS/manual/filters with Giehl chip, spare boards, Dave Heil |
Previous by Thread: | Re: [TenTec] Omni six-- heat related IF gain problem, denton |
Next by Thread: | Re: [TenTec] Omni six-- heat related IF gain problem, Ken Brown |
Indexes: | [Date] [Thread] [Top] [All Lists] |