TenTec
[Top] [All Lists]

Re: [TenTec] Omni six-- heat related IF gain problem

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Omni six-- heat related IF gain problem
From: "denton" <denton@oregontrail.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 13 Jul 2005 07:02:03 -0700
List-post: <mailto:tentec@contesting.com>
What I did to my Omni 6 is pull the speaker and install a small muffin fan 
in its place, as well as a second fan on the rf brick heat sink. A 50 ohm 
resistor in each fans B+ lead keeps the fan noise tolerable.
You may want to try this....
----- Original Message ----- 
From: "Chuck Guenther" <ni0c@earthlink.net>
To: <tentec@contesting.com>
Sent: Wednesday, July 13, 2005 6:44 AM
Subject: [TenTec] Omni six-- heat related IF gain problem


> For several weeks now, I've noticed a pronounced reduction in gain of my 
> Omni 6 after it has been on for a while.  When I first turn on the rig, I 
> get an s meter reading of s-2 to s-3 on antenna noise, which degrades to 
> s-0 after the rig has been on for a while.  The attenuation used to take a 
> few hours to kick in, but this morning I noticed fading out in a matter of 
> minutes.  Has anyone else experienced this?  I suspect a problem either on 
> the 9MHz board or the PBT board.  Any hints would be appreciated.
>
> Thanks & 73,
>
> Chuck  NI0C
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> 


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>