[TenTec] Omni six-- heat related IF gain problem

["Chuck Guenther" <ni0c@earthlink.net>]

For several weeks now, I've noticed a pronounced reduction in gain of my Omni 6 
after it has been on for a while.  When I first turn on the rig, I get an s 
meter reading of s-2 to s-3 on antenna noise, which degrades to s-0 after the 
rig has been on for a while.  The attenuation used to take a few hours to kick 
in, but this morning I noticed fading out in a matter of minutes.  Has anyone 
else experienced this?  I suspect a problem either on the 9MHz board or the PBT 
board.  Any hints would be appreciated.

Thanks & 73,

Chuck  NI0C
 
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec