Wild shot...sounds like you just have something else assigned to the same
COM port as you have the Orion assigned? Maybe reboot the PC, delete the
previous firmware update from your PC, and then open ONLY the v1.37 update
on your PC.
Tom - W4BQF
----- Original Message -----
From: "Jess Young" <w8jy@starband.net>
To: <tentec@contesting.com>
Sent: Wednesday, May 19, 2004 10:13 PM
Subject: RE: [TenTec] New Orion Firmware
> I have encountered an interesting problem. My Orion was communicating
> with my logging program before I shut the program down to download the
> Firmware update. When trying to install, the program says it cannot
> communicate with the Orion. Tried a master reset, rebooted the
> computer, etc. The logging program now tells me the port is already in
> use. Still can't install the new update. Any suggestions?
>
> Thanks,
>
> Jess, W8JY
>
> -----Original Message-----
> From: tentec-bounces@contesting.com
> [mailto:tentec-bounces@contesting.com] On Behalf Of J. Crit Harley
> Sent: Wednesday, May 19, 2004 21:44
> To: tentec@contesting.com
> Subject: [TenTec] New Orion Firmware
>
> Well, downloaded from net okay and uploaded to rig okay.
> BUT on tuning there is no difference in tuning rate whether use step 1,
> 10
> or 100. All step as if set at a step rate of 100. No fine tuning.
> Did I miss something?
> 73/Crit/K4BXN
>
> --
> Using Opera's revolutionary e-mail client: http://www.opera.com/m2/
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|