Dick,
I have not experienced the problem you described, but it sounds as if it is
related to N1MM's cycle though the three stages of an S&P ESM QSO. Watch the
highlighted Function Key buttons to make sure the Entry Window has advanced
to the next stage:
Stage #1. F4 CALL HIM - Enter sends the MyCallKey message when the callsign
field is empty or contains a legitimate callsign
Stage #2 F8 AGAIN? - Enter sends the AgainKey message when the exchange
field(s) does not contain a valid contest exchange. (NOTE: This stage is
bypassed when the "contest" rules do not require an exchange - for example a
DX dxpedition contest)
Stage #3. F2 EXCHANGE and LOG-IT - Enter sends the ExchangeKey message and
logs the QSO
The key to debugging your problem will be in identifying proper stage
sequencing in the Entry Window.
-larry (K8UT)
-----Original Message-----
From: RLVZ--- via RTTY
Sent: Monday, July 18, 2016 12:11 AM
To: rtty@contesting.com
Cc: rlvz@aol.com
Subject: [RTTY] N1MM Exch Message when using ESM?
Hi Guys,
I was going to post my question on the N1MM logger+ Digital reflector, but
since Don brought up a related subject, and since rtty@contesting .com is
easier for me to post messages on, I'd like to ask the following question
about N1MM Logger+:
For this weekends NAQP-RTTY Test, I was using N1MM Logger+ V.1.0.5785.0
(which I believe is the latest version) and using ESM. ESM worked
flawlessly
when running stations. But while hunting MULTS in S&P mode I frequently
had problems. After entering the other stations Callsign in the Callsign
field and pressing "Enter" the first time, ESM would always send my
Callsign
just as it should. But after filling the logging fields with the proper
received message and then pressing "Enter" the second time in order to send
my exchange and automatically log the Qso, about 30% of the time Logger+
sent my Callsign again rather than sending my report and logging the Q.
That
really messed me up and may have cost me logging some Q's because of it.
So I'm wondering if anyone else experienced a similar problem?
Thanks & 73,
Dick- K9OM
In a message dated 7/17/2016 11:16:18 A.M. Central Daylight Time,
rtty-request@contesting.com writes:
Message: 1
Date: Sat, 16 Jul 2016 17:58:33 -0500
From: "Don Hill AA5AU" <aa5au@bellsouth.net>
To: "'RTTY Reflector'" <rtty@contesting.com>
Subject: [RTTY] N1MM Exch Message when using ESM?
Message-ID: <000d01d1dfb5$950bfb00$bf23f100$@net>
Content-Type: text/plain; charset="us-ascii"
OK, I give up. How do your properly set up your F2 (EXCH) RUN message when
using ESM?
I want to send the other station's callsign ONCE with my report starting on
a new line.
Thanks,
Don AA5AU
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|