Is there a "manual" or any release/eratta notes for the KarlNet Ubicom FW
load somewhere?
Charles, does the "Init" switch on the converted Hawking Tech AP's do
anything with the KarlNet FW?
I haven't had any reports of it returning to "factory default" (probably
better described as "default settings") in the last week or so, but even
still, I'd really like to know if the units returning to default settings
is a KarlNet software bug of some kind, or a hardware issue that causes
them to lose their config.
BTW, it did completely lose it's configuration when the issue appeared -
returned to all default settings, IP address and all.
Otherwise, the units work very well in my opinion, and I'm very much
looking forward to others using them, volume going up and price coming
down ;)
Brad
> I have seen this happen on the ubicom units, some how they end up back
> in factory default, I remembering seeing something in the doc's about
> this
>
>
>
>> -----Original Message-----
>> From: karlnet-bounces@WISPNotes.com
> [mailto:karlnet-bounces@WISPNotes.com]
>> On Behalf Of Charles Chia Sheng Wu
>> Sent: Friday, August 08, 2003 11:47 PM
>> To: bradlists@mnns.com; Karlnet Mailing List
>> Subject: RE: Ubicom TC Units and factory reset issues/questions,
> WET11's-
>> was RE: [Karlnet] ofdm in 2.4ghz?
>>
>> >My question to KarlNet is (assuming they'll tell us) - what sequence
> of
>> >events has to happen in software to return the unit to factory
> defaults?
>> >Are the software routines for "factory reset" executed immediately on
>> >startup, or is there some kind of "wait for power and switch inputs
> to
>> >settle before doing anything" delay? If it were a switch actuation
> due
>> to
>> >vibration, I could just desolder it and be done with it really. But
> if
>> >it's a wait or debounce issue, I'm sort of out.
>>
>> there's no way to set a KarlNet Ubicom unit to "factory reset"
>>
>> >I know this is an oddball case, and I've not been able to reproduce
> it
>> >reliably, not even by repeated firm tapping on the housing or closing
> the
>> >door hard, but I know it's happening on this particular install
> regularly
>> >(every few days), and if I can't track it down, I'll either have to
>> >replace the bridge or move it elsewhere in the house and see what
>> happens.
>>
>> was this ever resolved? if not...send an email to support@cwlab.com,
> we'll
>> open a ticket, and get an RMA/replacement going
>>
>> -Charles
>>
>> _______________________________________________
>> Karlnet mailing list
>> Karlnet@WISPNotes.com
>> http://lists.wispnotes.com/mailman/listinfo/karlnet
>> --
>> [This E-mail scanned for viruses by Declude Virus]
>
>
> --
> [This E-mail scanned for viruses by Declude Virus]
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
|