I have seen this happen on the ubicom units, some how they end up back
in factory default, I remembering seeing something in the doc's about
this
> -----Original Message-----
> From: karlnet-bounces@WISPNotes.com
[mailto:karlnet-bounces@WISPNotes.com]
> On Behalf Of Charles Chia Sheng Wu
> Sent: Friday, August 08, 2003 11:47 PM
> To: bradlists@mnns.com; Karlnet Mailing List
> Subject: RE: Ubicom TC Units and factory reset issues/questions,
WET11's-
> was RE: [Karlnet] ofdm in 2.4ghz?
>
> >My question to KarlNet is (assuming they'll tell us) - what sequence
of
> >events has to happen in software to return the unit to factory
defaults?
> >Are the software routines for "factory reset" executed immediately on
> >startup, or is there some kind of "wait for power and switch inputs
to
> >settle before doing anything" delay? If it were a switch actuation
due
> to
> >vibration, I could just desolder it and be done with it really. But
if
> >it's a wait or debounce issue, I'm sort of out.
>
> there's no way to set a KarlNet Ubicom unit to "factory reset"
>
> >I know this is an oddball case, and I've not been able to reproduce
it
> >reliably, not even by repeated firm tapping on the housing or closing
the
> >door hard, but I know it's happening on this particular install
regularly
> >(every few days), and if I can't track it down, I'll either have to
> >replace the bridge or move it elsewhere in the house and see what
> happens.
>
> was this ever resolved? if not...send an email to support@cwlab.com,
we'll
> open a ticket, and get an RMA/replacement going
>
> -Charles
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
> --
> [This E-mail scanned for viruses by Declude Virus]
--
[This E-mail scanned for viruses by Declude Virus]
|