>My question to KarlNet is (assuming they'll tell us) - what sequence of
>events has to happen in software to return the unit to factory defaults?
>Are the software routines for "factory reset" executed immediately on
>startup, or is there some kind of "wait for power and switch inputs to
>settle before doing anything" delay? If it were a switch actuation due to
>vibration, I could just desolder it and be done with it really. But if
>it's a wait or debounce issue, I'm sort of out.
there's no way to set a KarlNet Ubicom unit to "factory reset"
>I know this is an oddball case, and I've not been able to reproduce it
>reliably, not even by repeated firm tapping on the housing or closing the
>door hard, but I know it's happening on this particular install regularly
>(every few days), and if I can't track it down, I'll either have to
>replace the bridge or move it elsewhere in the house and see what happens.
was this ever resolved? if not...send an email to support@cwlab.com, we'll
open a ticket, and get an RMA/replacement going
-Charles
|