Hello,
First of all, what do you mean by "to route out to the internet to hold
down on broadcast" ???
Are you using NAT on AP-1000 since in your example you stated that you
use private IPs which are not routeable outside your network ?
It would be good if you can send output of ip routes from configurator.
On Tue, 2003-07-01 at 18:27, wesley allison wrote:
> I just received all my equipment and Karlnet software and I am in the
> process of getting things squared away. I have setup my AP-1000 as a base
> station and my RG-1000 as a satellite. I have decided to route from my cpe
> to the base station and out to the internet to hold down on broadcast
> traffic. I am having a problem getting to the internet from my CPE. I can
> ping all the way back to the base station, but I can't get to the internet.
> I do have my Base setup as a bridge at this point but I have tried it both
> ways and I seem to get blocked at the base station. The way I would like to
> do it is at the CPE I run DHCP on the Ethernet connection and route that
> traffic to the wireless interface, then from that wireless interface to the
> base station wireless interface, then to the base station Ethernet interface
> and out on the internet and back. So I was checking to see if anybody had
> any suggestions. "quick note everything works fine in bridge mode all the
> way from the cpe to the internet, so the equipment is working fine."
>
> example
> 10.10.10.1 -----> 192.168.1.10 RG-1000 hooked to client computer
> cpe Ethernet cpe wireless
>
> 192.168.1.10 ------> 192.168.1.5 RG-1000 connected to AP-1000 base
> station
> cpe wireless base wireless
>
> 192.168.1.5--------> 192.168.1.1 AP-1000 base station connected to
> internet connection
> base wireless internet
>
> Thanks
>
> wes
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
--
Darko Delic <darko@tradal.net>
|