NO amps in the system. I just wanted to double check. I think it's a
mis-aligned antenna at the site, I told the installer to turn it 6*, he
turned it like 20*
Dan Metcalf
Wireless Broadband Sytems
dan.metcalf@wbsysnet.com
www.wirelessbroadbandsystems.com
> -----Original Message-----
> From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]
On
> Behalf Of Roger Boggs
> Sent: Wednesday, July 24, 2002 12:22 PM
> To: karlnet@WISPNotes.com
> Subject: RE: [Karlnet] FCS errors
>
> No, the client can't tell how well the AP is hearing him, he can only
tell
> how well he is hearing the client. Isn't there a signal level and
noise
> level
> indication at the AP to tell how he's receiving the client?
>
> Amplifiers on the AP and not on the client are a typical way to make
> this happen. Client hears the amplified AP just fine, but doesn't
have
> the
> power to get back equally.
>
> At 12:19 PM 7/24/02 -0400, you wrote:
> >Lets say it's a weak or low signal from the client, would anything on
> >the client indicate this?
> >
> >
> >
> >Dan Metcalf
> >Wireless Broadband Sytems
> >dan.metcalf@wbsysnet.com
> >www.wirelessbroadbandsystems.com
> >
> >
> >
> > > -----Original Message-----
> > > From: karlnet-admin@WISPNotes.com
[mailto:karlnet-admin@WISPNotes.com]
> >On
> > > Behalf Of Roger Boggs
> > > Sent: Wednesday, July 24, 2002 12:07 PM
> > > To: karlnet@WISPNotes.com
> > > Subject: RE: [Karlnet] FCS errors
> > >
> > > No, that isn't necessarily the case. This is indicating to you
that
> >the
> > > AP1000 wireless interface is having a difficult time hearing the
> >client.
> > > Probable causes are interference or insufficient signal. If it's
> > > interference,
> > > the problem won't necessarily affect the client since it may be
coming
> > > from
> > > a different direction or the source is closer to the AP than the
> >client.
> > >
> > >
> > > At 11:54 AM 7/24/02 -0400, you wrote:
> > >
> > > >I have an ap1000 which is on radio B. and we are seeing a very
HIGH #
> >of
> > > >FCS errors (In errors). There is only 1 CPE on this radio,
should I
> >see
> > > >the same # errors on the Outside of the CPE?
> > > >
> > > >Dan Metcalf
> > >
> > > RB
> > >
> > > _______________________________________________
> > > Karlnet mailing list
> > > Karlnet@WISPNotes.com
> > > http://lists.wispnotes.com/mailman/listinfo/karlnet
> > > ---
> > > [This E-mail scanned for viruses by Declude Virus]
> >
> >
> >---
> >[This E-mail scanned for viruses by Declude Virus]
> >
> >_______________________________________________
> >Karlnet mailing list
> >Karlnet@WISPNotes.com
> >http://lists.wispnotes.com/mailman/listinfo/karlnet
>
> RB
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
> ---
> [This E-mail scanned for viruses by Declude Virus]
---
[This E-mail scanned for viruses by Declude Virus]
|