Amps
[Top] [All Lists]

Re: [Amps] Getting a blower out of the shack

To: "Rick Stealey" <rstealey@hotmail.com>, <amps@contesting.com>
Subject: Re: [Amps] Getting a blower out of the shack
From: "Carl" <km1h@jeremy.mv.com>
Date: Tue, 9 Apr 2013 21:10:50 -0400
List-post: <amps@contesting.com">mailto:amps@contesting.com>
I would consider a dryer hose since they come in several sizes and have various sheetmetal ends that go to the outside vent. Mine is square.
I see no need for anything high priced since temperature is low as is the 
air pressure.
Carl
KM1H


----- Original Message ----- From: "Rick Stealey" <rstealey@hotmail.com>
To: <amps@contesting.com>
Sent: Tuesday, April 09, 2013 5:14 PM
Subject: [Amps] Getting a blower out of the shack


I have a homebrew amp with a blower mounted on the back of the chassis. The blower has a flat flange, and the chassis has a rectangular hole cut in it to match. What I would like to do, to reduce blower noise, is to remote the blower about 6 feet away (actually into the basement immediately below the amplifier rack.) I need a means of converting the blower flange to a round hose, and the compliment of that at the amplifier. I will run the 6 feet of hose through the sheetrock wall, and down through the sole plate into the basement, so the maximum hose diameter is 3.5 inches (it will go through a 2 X 4 sole plate).
Any ideas where to get parts I would need?

Rick  K2XT

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps


-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 10.0.1430 / Virus Database: 2641/5734 - Release Date: 04/09/13

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>