I have a homebrew amp with a blower mounted on the back of the chassis. The
blower has a flat flange, and the chassis has a rectangular hole cut in it to
match.
What I would like to do, to reduce blower noise, is to remote the blower about
6 feet away (actually into the basement immediately below the amplifier rack.)
I need a means of converting the blower flange to a round hose, and the
compliment of that at the amplifier. I will run the 6 feet of hose through the
sheetrock wall, and down through the sole plate into the basement, so the
maximum hose diameter is 3.5 inches (it will go through a 2 X 4 sole plate).
Any ideas where to get parts I would need?
Rick K2XT
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|