A store that sells woodworking equipment is your best bet.
Try rockler.com or woodcraft.com
Look under "dust collection". Both have stores...perhaps near where you
live.
Also try Home Depot or Lowes. They carry different sizes of dryer hoses
and fittings to go with them.
On 4/9/2013 4:14 PM, Rick Stealey wrote:
I have a homebrew amp with a blower mounted on the back of the chassis. The
blower has a flat flange, and the chassis has a rectangular hole cut in it to
match.
What I would like to do, to reduce blower noise, is to remote the blower about
6 feet away (actually into the basement immediately below the amplifier rack.)
I need a means of converting the blower flange to a round hose, and the
compliment of that at the amplifier. I will run the 6 feet of hose through the
sheetrock wall, and down through the sole plate into the basement, so the
maximum hose diameter is 3.5 inches (it will go through a 2 X 4 sole plate).
Any ideas where to get parts I would need?
Rick K2XT
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
--
73,
Gary K9GS
Greater Milwaukee DX Association: http://www.gmdxa.org
Society of Midwest Contesters: http://www.w9smc.com
CW Ops #1032 http://www.cwops.org
************************************************
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|