A.I have 6.4kk applied
B. I keep moisture away from my equipment
C.My mounting hole is as large as necessary to accomodate mounting
D. I don`t gamble,I am a craftsman...If you ever see my work you will most
likely agree.
E.You should improve on your metal working..Good Luck!
Jim..K7RDX..
----- Original Message -----
From: "Phil Clements" <philc@texascellnet.com>
To: "'k7rdx'" <k7rdx@charter.net>; "'Carl'" <km1h@jeremy.mv.com>;
<felipe@dxwatch.com>; <Amps@contesting.com>
Sent: Tuesday, January 12, 2010 7:02 PM
Subject: Re: [Amps] which HV connector to use?
>
>
>> I have used Millens since 1972 and have NEVER had that
> happen...Jim..K7RDX..
>
> Reasons that you have not had a Millen connector arc:
> A. You have not applied over 4-5 KV for an extended amount of time
> B. You live in a very dry environment
> C. Your mounting hole is much larger than the diameter of the connector.
> D. If none of the above applies to you, you are extremely lucky, and
> should
> purchase a power ball lottery ticket immediately!
>
> (((73)))
> Phil, K5PC
>
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
--------------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.432 / Virus Database: 270.14.136/2616 - Release Date: 01/12/10
07:35:00
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|