Insofar as knob size, setscrew type, etc is concerned , I think it's all a
matter of personal concern. !!!
I have used big knobs, little knobs, slotted head setscrews, allen heads
, spline type screws, and they all are good within their limitations. !!
Me?? I prefer spline type setscrews, but the allen type seems to be the most
prevalent today !!! And a knob of about 1- 1/12 seems to be about average,
again it's a matter of personal preference.
carl / kz5ca
----- Original Message -----
From: "Vic Rosenthal" <vic@rakefet.com>
To: <amps@contesting.com>
Sent: Tuesday, February 25, 2003 1:05 PM
Subject: Re: [Amps] KNOB ORIENTATION
> W0YR@aol.com wrote:
> >
> > Further, I'd
> > like to have some suggestions as to knob size and the recommended number
of
> > set screws...and...this is important....whether they should have slotted
> > screw heads or heads requiring an Allen wrench.
>
> Everyone knows that slotted screws are at least 11db worse from an IMD
> standpoint.
>
> Vic K2VCO
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
|