I think it's not a matter of "should" or "should not," but most appliances
having such a control are labeled "100" when the plates are fully UN-meshed
(minimum capacitance), by convention.
WB2WIK/6
"Success is the ability to go from failure to failure with no loss of
enthusiasm." -Winston Churchill
> -----Original Message-----
> From: W0YR@aol.com [SMTP:W0YR@aol.com]
> Sent: Monday, February 24, 2003 3:19 PM
> To: amps@contesting.com
> Subject: [Amps] KNOB ORIENTATION
>
> Can someone please clarify:
>
> Should the pointer on knob of an antenna loading capacitor shaft point to
> 100
> when the plates are fully meshed, or should it point to zero?
>
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
|