[Amps] KNOB ORIENTATION

To:	<amps@contesting.com>
Subject:	[Amps] KNOB ORIENTATION
From:	philk5pc at tyler.net (Phil Clements)
Date:	Mon Feb 24 18:54:16 2003



> Can someone please clarify:
>
> Should the pointer on knob of an antenna loading capacitor shaft point to 100
> when the plates are fully meshed, or should it point to zero?


The plates are set at full-mesh, and the pointer is set to zero.
Zero=minimum loading and 100=maximum loading.

(((73)))
Phil, K5PC

<Prev in Thread]	Current Thread	[Next in Thread>
[Amps] KNOB ORIENTATION, W0YR@aol.com [Amps] KNOB ORIENTATION, Guillermo [Amps] KNOB ORIENTATION, Phil Clements <= [Amps] KNOB ORIENTATION, Steve Katz [Amps] KNOB ORIENTATION, wb8jkr@juno.com [Amps] KNOB ORIENTATION, W0YR@aol.com [Amps] KNOB ORIENTATION, Vic Rosenthal [Amps] KNOB ORIENTATION, carl seyersdahl [Amps] KNOB ORIENTATION, carl seyersdahl [Amps] KNOB ORIENTATION, Steve Katz [Amps] KNOB ORIENTATION, Steve Katz [Amps] KNOB ORIENTATION, carl seyersdahl [Amps] KNOB ORIENTATION, carl seyersdahl

Previous by Date:	[Amps] KNOB ORIENTATION, wb8jkr@juno.com
Next by Date:	Fw: Re: [Amps] 2879 biasing, Dennis12Amplify@aol.com
Previous by Thread:	[Amps] KNOB ORIENTATION, Guillermo
Next by Thread:	[Amps] KNOB ORIENTATION, Steve Katz
Indexes:	[Date] [Thread] [Top] [All Lists]