Hi Nick - it's a north-centered rotor and box. I'm wondering if the rotor
is just *set* to north, but is setting on the tower with "north" to the
"south", with the antennas themselves pointing north. In other words, in
need of a physical rotation. Haha.
Thanks,
Rob Matherly, W0JRM
Centerville, Iowa - EN30nr
NAQCC #7688, SKCC #29, FISTS #19246, QRP ARCI #16952
http://w0jrm.robmatherly.com
On Wed, Aug 4, 2021 at 3:46 PM Nick via TowerTalk <towertalk@contesting.com>
wrote:
> Rob, when you set the rotor to North, you didn’t mention if the rotor was
> set with south centered or north centered. Did you align the rotor to north
> by rotating it clockwise rather than rotating it counterclockwise? If so
> then it will only rotate counterclockwise on a south centered.
> Sounds like a physical rotation is needed.
> As always my old memory is in play so your case might be completely
> different.😏
> Nick……WB7PEK
>
> From: john@kk9a.com
> Sent: Wednesday, August 4, 2021 12:52 PM
> To: towertalk@contesting.com
> Subject: Re: [TowerTalk] Rotator won't turn east
>
> So when you say that it worked properly on the bench, I assume that you
> mean
> it rotated completely from south to south and then you set it to north
> prior
> to installing. If this is a Hy-Gain rotator their mast clamp needs to be
> shimmed for most common mast diameters. Perhaps the mast is jamming?
>
>
>
> Rob Matherly W0JRM wrote:
>
> Hi all -
>
> Question that's hopefully got a simple answer. I have a bell rotor that was
> recently overhauled. I hooked it up to my controller before installing it
> on the tower and verified that everything worked properly.
>
> I set the rotor to north before putting it up, and oriented my beam that
> direction. When I try to rotate it, the rotator will only turn to the South
> counter-clockwise. If I try to go South clockwise (i.e., turn it to the
> east) it will stop at North. I've verified that the coax isn't hung up on
> anything and that there's no obstructions.
>
> Any ideas? I wondered if perhaps the rotator is mounted 180 from where it
> needs to be and I just need to go spin it around or something.
>
> Thanks,
> Rob Matherly, W0JRM
> Centerville, Iowa - EN30nr
> NAQCC #7688, SKCC #29, FISTS #19246, QRP ARCI #16952
>
> http://w0jrm.robmatherly.com
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|