The bolts in that plate should be up with the nuts and the connections
on top so they can be reached easily. Tighten a nut and lockwasher on
the bolt to lock it to the plate, then add the radials (I use 1/4"
terminals on each wire) and tighten the top nut.
Les W2LK
On 8/28/2018 1:59 PM, Roger D Johnson wrote:
I just wish the DXE radial plate had the holes tapped for 1/4-20. It's
a pain
getting to the underside with a wrench to remove the nut when you have
a bunch
of radials attached.
73, Roger
On 8/24/2018 1:46 PM, W0MU Mike Fatchett wrote:
DXE makes great radial plate. That is really not what the question
is about.
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|