Re: [Karlnet] Wacko Karlnet

[wireless@peake.com]

Norm, Went out of the area for the weekend but I kept thinking about this 
issue.  It seems really strange that both the CPE and my Laptop both stop 
working so I'm leaning towards a AP problem.  I'm also unable to PING or 
link test with the AP for my two wireless devices.  I'm going try with a 
hard-wire IP.

I did reboot the AP before I sent the first email and my two vendors that 
have my CPEs are not having a problem (I did a voice call on Friday)

So I'm leaning towards the AP but I'm at a loss and my tech support call to 
my vendor last Thursday has gone unanswered.

Chris


At 11:02 PM 07/12/2003 -0700, you wrote:
> Try pinging the AP rather than going all the way to the 'net first, if you
> haven't already.  Can you link test with the AP?
>
> Norm
>
> ----- Original Message -----
> From: <wireless@peake.com>
> To: "Karlnet Mailing List" <karlnet@WISPNotes.com>
> Sent: Friday, July 11, 2003 12:44 PM
> Subject: [Karlnet] Wacko Karlnet
>
>
> > What a day  ;)  Now my reliable notebook with Orinoco PC card is acting
> > up.  This laptop has been off for a few weeks.  I turn it on this morning
> > and I'm unable to connect to the Net.  The TurboCell signal strength in
> the
> > systray shows good.  I have a public IP address assigned to this
> > LT.  Nothing has been added/removed from the Laptop and the Wireless
> > Network in the Control Panel (w98se) shows all the right setting like
> > Frequency, Network etc.
> >
> > I used to be able to run the Karnet ConfigeV Bridge Configuration program
> > and actually looks at my AP and other CPEs that I have (AP and CPE are all
> > public IP, really small network).
> > Now when I open remote config and press the scan button I get the "Unable
> > to locate any device" error.
> >
> > I've rebooted the AP and the two other CPEs that are outside the building
> > are working just fine.
> >
> > But my Spare CPE is also not working before and after I flashed it from a
> > SR-4100 to a SR-4200.  Using a crossover cable and NIC I can access the
> > CPE, use the configV program to flash etc but I'm unable to get the CPE to
> > talk to the AP.
> >
> > Open to suggestions.
> >
> > Thanks
> > Chris
> > wireless@peake.com
> >
> > ---
> > [This E-mail scanned for viruses by Declude/F-Prot AV]
> >
> > _______________________________________________
> > Karlnet mailing list
> > Karlnet@WISPNotes.com
> > http://lists.wispnotes.com/mailman/listinfo/karlnet
>
>
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
> ---
> [This E-mail scanned for viruses by Declude/F-Prot AV]

---
[This E-mail scanned for viruses by Declude/F-Prot AV]