Carl,
Thanks very much. It's working as it should. I had run just TXD, RXD & Signal
Ground as used by the Omni VI and completely overlooked handshaking. So, I
added 2 wires to the cable and turned on the handshake in N1MM. The real crime
is that I worked in data communications for 14 years. Guess I've been retired
too long.
Anyway, thanks again very much.
Merry Christmas and Happy New Year to you and yours
73
Dave
WA3F
----- Original Message -----
From: "N4PY" <n4py2@earthlink.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Friday, December 24, 2010 3:15:03 PM
Subject: Re: [TenTec] Omni VII Serial Port
57600 baud, 8 bit, no parity, RTS/CTS signalling.
Carl Moreschi N4PY
121 Little Bell Dr
Hays, NC 28635
www.n4py.com
----- Original Message -----
From: <d.e.warnick@comcast.net>
To: <tentec@contesting.com>
Sent: Friday, December 24, 2010 2:52 PM
Subject: [TenTec] Omni VII Serial Port
>
>
> Just got an Omni VII today. Trying to get it to talk to N1MM or vice
> versa. Nothing in manual on serial port parameters to set in N1MM and I
> haven't found anywhere I can set them in the Omni VII
>
>
>
> Anybody care to point me in the right direction
>
>
>
> Thanks
>
> Dave
>
> WA3F
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|