57600 baud, 8 bit, no parity, RTS/CTS signalling.
Carl Moreschi N4PY
121 Little Bell Dr
Hays, NC 28635
www.n4py.com
----- Original Message -----
From: <d.e.warnick@comcast.net>
To: <tentec@contesting.com>
Sent: Friday, December 24, 2010 2:52 PM
Subject: [TenTec] Omni VII Serial Port
>
>
> Just got an Omni VII today. Trying to get it to talk to N1MM or vice
> versa. Nothing in manual on serial port parameters to set in N1MM and I
> haven't found anywhere I can set them in the Omni VII
>
>
>
> Anybody care to point me in the right direction
>
>
>
> Thanks
>
> Dave
>
> WA3F
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|